This die-cut pendant is the perfect companion to a celtic-themed card

What you need...

• Spellbinders™ products:
  
  Die-cutter, Artisan X-Plorer™
  Dies: Rectangles One MD1-003, Celtic Motifs S5-163
  Bezel, Rectangles One MB1-003
  
  other items
  
  Card, black
  Art engraving board, gold
  Resin, ICE
  Wire, bronze, 18 gauge
  Beads
  Cord, cotton
  Glue
  Sanding block
  Hammer

instructions

1. Pendant - 1 Die-cut black card using Rectangles One Die #3 and glue to a bezel. Using a celtic motifs rectangle border die, cut an art engraving board, then sand to reveal gold on the raised areas. Adhere to the inside of the bezel over the card.
   
   2 Mix ICE Resin according to the manufacturer’s instructions. Slowly pour into the bezel until the desired level is reached, then set aside to dry for at least six hours. Hammer bronze wire, 10cm, flat, then create a bail for the bezel.
   
   3 Create a wire-wrapped dangle from miscellaneous beads and wire, then attach to the loop at the bottom of the bezel. String cord of your choice through the bail at top of the bezel to complete.